Solar Water Stills: Principles And Application

Since the 1980s, no large-capacity solar distillation plants have been built, mainly for the following reasons: Large installation areas are needed, solar distillation plants have low efficiencies, and solar water desalination has been developed, which in some cases can replace solar distillation (e.g., for medium-size communities). (more…)

Absorption Refrigeration Systems: Principles and Advantages of Cooling

The idea of using an absorption fluid as a refrigerant carrier derived from the drawback of VCR (vapor–compression refrigeration) systems that the gas compression requires a high work input. A pump that requires practically no work to increase the pressure in the refrigeration system replaces the complicated and work-consuming compressor. There are two major advantages of absorption refrigeration systems (ARSs) compared with VCRs (vapor–compression refrigeration): No CFCs or HCFCs are used as refrigerants, and they use heat from different sources, such as combustion, industrial processes, waste heat (an economical solution for recovery), or solar heat. (more…)

Solar Distillation Process

Solar distillation is the process in which solar heat is used to purify water from an impure water source by evaporation and condensation. When solar distillation is used to purify water from saline water, the process is also called solar desalination. Desalination converts saline water with high salt content, about 3.5% by weight in seawater and about 0.6% in brackish water, into fresh water suitable for drinking and other purposes. Use solar energy can be used for desalination, either as thermal energy through the use of solar thermal collectors or solar ponds, or as electricity. mainly through the use of photovoltaic cells. (more…)

Heat Exchangers, Evaporators, and Condensers | Energy Application of Micro Technology

The most fundamental process from an energy systems standpoint is heat transfer to (or from) a working fluid. This unit operation typically occurs in small channels, the characteristic diameter of which is less than 1 mm. Other heat transfer exchanger configurations, such as fluid flowing through a network of posts or through a mesh, are also possible. Specific examples of this fundamental unit operation include phase change occurring in boilers (modular steam boiler), evaporators, and condensers. (more…)

Geothermal Drilling for Investigating Geothermal Resource

Geothermal drilling technology is adapted from the oil industry. Most of the geothermal wells are drilled with a rotary-type drilling rig. Because of the hard, abrasive, and high-temperature volcanic rocks of geothermal systems, the drilling bits require hard abrasive resistant teeth such as diamond or tungsten carbide. Hence, geothermal drilling is an expensive activity in geothermal development. Most geothermal wells are drilled 1 to 2 km deep to intersect faults and fractures so as to increase the success rate of production from permeable zones. (more…)

Microreactors, Combustors and Fuel Reformers | Energy Application of Micro Technology

Microtechnology-Based Energy and Chemical Systems will most likely employ combustion for driving processes such as vapor generation and vapor barrier, endothermic chemical reactions, and (most notably) fuel reforming. Both fuel reformers and combustors will be of a miniature design relying on embedded catalysts for promoting chemical reactions at moderate temperatures (350–7501C). Many potential configurations exist depending on the application and constraints on the design. Microchannel arrays are a potential configuration; mesh and post architecture is another to achieve the desired surface area and small diffusional lengths necessary. (more…)

Coal Use for Electricity Generation Power

Coal Electricity Generation
The largest use of coal today is in the generation of electric power by electric utilities. According to the U.S. Energy Information Administration, about 65% of coal mined in the world is used for power generation. The next largest use of coal is in the production of coke for the iron and steel industries. Coal is still used for industrial heating and even commercial heating and residential heating in certain countries. (more…)

High Enthalpy Geothermal Energy

“Spain has great potential but lack geothermal legislation and investment.” Besides being clean, renewable and friendly, easily manageable, which contributes to security of energy supply.

However, like other renewable energy sources, requires the development of sustainable energy technology push policies and efficient and environment economic support. (more…)

Years of Wasted Wind Energy from Electricity Consumption

Canary wasted much of the wind power produced with wind farms, the current and anticipated, until they are built pumping stations capable of almacenarla. Not be at least until 2015. (more…)

Taking Benefits of Wind Energy Electricity

benefits of wind energy electricity
Wind energy comes from the mismatched heating system of the planet that runs all day and night, heated and cooled by the sun. They are also come as effect of the different between land and sea heat temperature, and natural barriers such as mountains. (more…)