Health Benefits Of Household Energy Transitions

household energy consumption
Reducing exposure to indoor air pollution from household energy use can be achieved through interventions in of the following areas:

* Emissions source and energy technology (fuel– stove combination).
* Housing design and ventilation.
* Behavior and time–activity budget. (more…)

Hydropower Research and Development Focusing in Turbine Efficiency

hydropower efficiency
Up to around 1980, hydropower research and development (R&D) efforts focused mainly on improving turbine efficiency, reducing cavitations, and increasing generation. Whereas older units had efficiency ratings as low as 60%, the new units have efficiency ratings of approximately 90%. The U.S. Department of Energy (DOE) also looked at new technologies for developing low-head, ultra low-head, and small hydropower projects. These technologies included the following: (more…)

Hydropower Energy Facts Pros and Cons

hydropower pros and cons
The World Commission on Dams (WCD) was formed in 1998 by a joint initiative of the World Conservation Union (IUCN) and the World Bank (WB) after a historic meeting of leading dam proponents and opponents in Switzerland, with proceedings reported by Dorcey and others. The WCD was asked to discover the truth about the hydropower energy facts, hydropower energy pros and cons, cost, effect, and benefit of large dams and it functioned independently for 2 years at a cost of $10 million. The money was well spent, and at the end of that period the WCD produced a comprehensive report and numerous support documents, and then dissolved itself. The report and support documents remain on the Internet available to all, and they have changed forever the debate about dams. (more…)

Primary Energy Use and Clean Coal Technology

clean coal technology
Transportation is another sector that has increased its relative share of primary energy use. This sector has serious concerns as it is a significant source of CO2 emissions and other airborne pollutants, and it is almost totally based on oil as its energy source. An important aspect of future changes in transportation depends on what happens to the available oil resources, production and prices. At present, 95% of all energy for transportation comes from oil. (more…)

Global Energy Consumption & Energy Demand in Electricity and Transportation

global energy demand
Global energy consumption in the last half century has increased very rapidly and is expected to continue to grow over the next 50 years. However, we expect to see significant differences between the last 50 years and the next. The past increase was stimulated by relatively “cheap” fossil fuels and increased rates of industrialization in North America, Europe, and Japan; yet while energy consumption in these countries continues to increase, additional factors are making the picture for the next 50 years more complex. These additional complicating factors include the very rapid increase fuel economy in energy use in China and India (countries representing about a third of the world’s population); the expected depletion of oil resources in the not-too-distant future; and the effect of human activities on global climate change. (more…)

UK Energy Demand: The United Kingdom Trends in Energy

uk energy demand
The long-term prospects for the U.K. economy are inevitably uncertain, and the most recent Department of Energy long-term projection puts forward three scenarios for the next 30 years with GDP growth rates of roughly 2.5, 1.5 and 0.5% p.a. The highest value corresponds to slightly less than the 1948 - 72 average, the central value is close to the long-run average over the last 80 years, and the lowest figure is similar to the performance during the current recession since 1973. (more…)

Nuclear Generating Capacity In The United Kingdom

nuclear united kingdom
Following the recent completion of three nuclear power plants, there is now some 9.6 GW of nuclear capacity in the United Kingdom. The nuclear share of electrical output, which has stood at around 13% for many years, should rise to around 20% when this capacity is in full operation. A further two reactors are currently under construction which will increase the British nuclear capacity to more than 12 GW by the late 1980s, which could bring the nuclear share of electrical output to around 25%. (more…)

Aerodynamic Force Sources: Pressure & Shear Stress

The next time you hear an airplane flying overhead, look up, and pause for a moment. What you see is a machine that is heavier than air, but which is somehow being sustained in the air. This is due to the airflow over the airplane. This airflow exerts a lift force which counteracts the weight of the airplane and sustains it in the air—a good thing. The airflow also exerts a aerodynamic drag force on the airplane which retards its motion—a bad thing. The drag must be counteracted by the thrust of the engine in order to keep the airplane going. The production of thrust by the engine consumes energy. Hence, the energy efficiency of the airplane is intimately related to aerodynamic drag. This is just one of many examples where the disciplines of aerodynamics and energy interact. (more…)

Photo-Electrochemical Energy Conversion Device

The basic processes that occur in such a system are well understood. The semiconductor electrode efficiently absorbs light, producing an excited electronic state. In this excited state, the electron and the electron vacancy (the ‘‘hole’’) are both more energetic than they were in their respective ground states. The photo-excited electrons and holes are generally not tightly bound to an individual atom or set of atoms in the solid. (more…)

Fiber-Optic Terminals Energy Consumption

Fiber-Optic energy
Fiber optic systems have many advantages on the basis of the communication systems technology compare to metallic media communication. These advantages include lower interference, small signal attenuation and bandwidth characteristics. In addition, relatively small cross-section of the fiber optic cable from a substantial growth in capacity in the existing lines is replaced. Properties of optical fibers can be classified as linear and nonlinear. Non-linear properties are influenced by parameters such as bit rate, channel spacing, and the level of performance. (more…)

Next Page »