Global energy consumption in the last half century has increased very rapidly and is expected to continue to grow over the next 50 years. However, we expect to see significant differences between the last 50 years and the next. The past increase was stimulated by relatively “cheap” fossil fuels and increased rates of industrialization in North America, Europe, and Japan; yet while energy consumption in these countries continues to increase, additional factors are making the picture for the next 50 years more complex. These additional complicating factors include the very rapid increase fuel economy in energy use in China and India (countries representing about a third of the world’s population); the expected depletion of oil resources in the not-too-distant future; and the effect of human activities on global climate change. (more…)
The relationship of gross national product per capita to energy consumption per capita for most countries of the world correlat ...
The long-term prospects for the U.K. economy are inevitably uncertain, and the most recent Department of Energy long-term proje ...
Transportation is another sector that has increased its relative share of primary energy use. This sector has serious concerns ...
The development of the ‘‘new’’ wind and solar technologies is of great importance for the future contribution of RESs to energy sup ...
To determine the effects of past climate trends on global energy consumption, the econometric equations providing the degree day el ...
Fiber optic systems have many advantages on the basis of the communication systems technology compare to metallic media communication. These advantages include lower interference, small signal attenuation and bandwidth characteristics. In addition, relatively small cross-section of the fiber optic cable from a substantial growth in capacity in the existing lines is replaced. Properties of optical fibers can be classified as linear and nonlinear. Non-linear properties are influenced by parameters such as bit rate, channel spacing, and the level of performance. (more…)
There are literally thousands of uses for lasers. One of the largest applications is telecommunications—sending a signal throug ...
Several passive heating systems, if provided with proper ventilation, can ensure to provide cooling. Passive heating and cooling fo ...
Most discussions of energy use in paper production and papermaking are confusing because of a failure to define exactly what is mea ...
More than 48% of the raw material fiber used for paper production (chemical pulp or mechanical pulp) in the United States in 2002 w ...
Different lasers use different materials as the active medium. The medium can be either solid, liquid, or gas, and there are ad ...
Various provisions in the federal income tax treat energy producers more or less favorably than other businesses. By changing the after-tax rate of return on investments in the energy sector, the Tax Code may alter the long-run supply of specific types of energy.
In general, the income of all participants in the energy sector is subject to income tax of one form or another. Two notable exceptions arise in the generation and sale of electricity. Governmental agencies (such as the Tennessee Valley Authority, the Bonneville Power Administration, and municipally owned power companies) account for approximately 14 percent of the electricity sold in the United States. (more…)
Taxation of energy in the United States, the federal government does not impose an energy tax or a general sales tax that is br ...
A number of countries have vehicle tax incentives programs designed to reward purchasers and owners of alternative fuel-efficient v ...
The primary purpose of all forms of taxation, whether on energy or on non-energy items, is to raise money for the government to fin ...
Economists have overwhelmingly favored fuel taxes over fuel economy standards as a means to reduce fuel or gasoline consumption ...
Federal Excise Taxes placed on specific energy sources tend to reduce energy demand for these energy sources in both the short ...
Power generation and distribution networks are built with spare capacity to meet peak periods of energy consumption is usually a time when demand for heating and / or cooling is particularly acute accommodate. Normally, peak electricity demand in some cases last just a few hours every year. And while the networks have always had to cope with peaks in recent years, the electricity consumption during peak hours has increased dramatically in the afternoon. (more…)
Here, the sensitivity of energy demand to climate is measured two ways. The first method uses elasticities that provide simple summ ...
HVAC (heating, ventilation, and air-conditioning) systems vary depending on the complexity of room units size from single rooms ...
To determine the effects of past climate trends on global energy consumption, the econometric equations providing the degree day el ...
After lighting, personal computers (PC) and monitors have the highest energy use in office environments. Studies have shown tha ...
The office copy machines (photocopier) is everywhere. Seven millions unit are in used in the United States and more than 1.5 mi ...
Different lasers use different materials as the active medium. The medium can be either solid, liquid, or gas, and there are advantages for each in the amount of energy that can be stored, ease of handling and storage, secondary safety hazards, cooling properties, and physical characteristics of the laser output. (more…)
There are literally thousands of uses for lasers. One of the largest applications is telecommunications—sending a signal throug ...
The word “laser” is an acronym for “light amplification by the stimulated emission of radiation.” Lasers of all kinds consist o ...
The first known laser was made by Theodore Maiman at Hughes Research Laboratories in Malibu, California, in 1960, but the seeds ...
Several molecular systems have been constructed that mimic various aspects of photosynthesis. Two of these utilize molecular system ...
It is known that laser printers print faster, but swallow a large amount of energy, even if the printer is in the energy saving ...
The term cryogenics derives from the Greek kryos, for icy cold. The upper limit that characterizes the cryogenic region of the temperature scale is subjective. If the delimitation criterion takes into consideration practical reasons, then this upper limit can be established at a higher than usually declared value (120 K) in order to include natural gas fuel liquefaction. The cryogenics region of the temperature scale 0–120 K can be divided into sub regions according to the criteria of the cryogenic method and refrigerant (known as crycoolers) as follows: (more…)
The idea of using an absorption fluid as a refrigerant carrier derived from the drawback of VCR (vapor–compression refrigeration) s ...
Micro technology can be employed to produce miniaturized refrigeration and cryocooling systems. Although process intensificat ...
The issues of hydrogen storage run through the hydrogen production, hydrogen transport, supply and demand for end use of hydrog ...
n fabricating microscale energy systems, a number of operating conditions must first be taken into account. Foremost are the op ...
Many small-scale energy systems require effective miniaturized pumps and expanders. These devices are responsible for conveying ...
The idea of using an absorption fluid as a refrigerant carrier derived from the drawback of VCR (vapor–compression refrigeration) systems that the gas compression requires a high work input. A pump that requires practically no work to increase the pressure in the refrigeration system replaces the complicated and work-consuming compressor. There are two major advantages of absorption refrigeration systems (ARSs) compared with VCRs (vapor–compression refrigeration): No CFCs or HCFCs are used as refrigerants, and they use heat from different sources, such as combustion, industrial processes, waste heat (an economical solution for recovery), or solar heat. (more…)
Heat-actuated heat pumps are cooling systems requiring no electricity for operation. Rather, a heat source is used, avoiding the ne ...
The term cryogenics derives from the Greek kryos, for icy cold. The upper limit that characterizes the cryogenic region of the temp ...
Separation is a unit operation used in absorption heat pumps and chemical processing applications such as solvent extraction and pr ...
Active solar hot water systems water are usable with air, liquid, vapor or liquid collector fluid or gas to liquid process. Hot ...
Micro technology can be employed to produce miniaturized refrigeration and cryocooling systems. Although process intensificat ...
There are literally thousands of uses for lasers. One of the largest applications is telecommunications—sending a signal through fiber optic cables, for example. This application grew rapidly in the 1990s with the phenomenal increase in traffic on the Internet. Optical data storage, such as on compact disks, CD-ROMs, and DVDs, is another important use for lasers. The information age was obviously a boon to this application, and as researchers obtained smaller wavelengths with diode lasers, they were able to fit more information on smaller storage devices. (more…)
Different lasers use different materials as the active medium. The medium can be either solid, liquid, or gas, and there are ad ...
The word “laser” is an acronym for “light amplification by the stimulated emission of radiation.” Lasers of all kinds consist o ...
The first known laser was made by Theodore Maiman at Hughes Research Laboratories in Malibu, California, in 1960, but the seeds ...
Several molecular systems have been constructed that mimic various aspects of photosynthesis. Two of these utilize molecular system ...
It is known that laser printers print faster, but swallow a large amount of energy, even if the printer is in the energy saving ...
Drying is one of the most important post harvest steps. It enhances the storage life of the crop products, minimizes losses during storage, and saves shipping costs. The drying process is the removal of water from the wet surface of the food. In this process, heat is transferred by convection and radiation to the surface of the produce. This heat raises the temperatures heat and evaporates the moisture from the exterior of the agricultural products, diffusing the interior moisture to the surface and replenishing the evaporated surface moisture. (more…)
Solar dryers are special structures that enhance the drying power of the sun and protect the agricultural product from dust, dirt, ...
The moisture content of the feedstock affects the gas composition and the energy balance of the process since gasification is an en ...
Biomass Storage Biomass storage is required to ensure the continuous operation of the facility. To limit the space required for ...
As a result of high and rising costs of fossil fuels and fossil fuels affect global environment concern , and by the reduction ...
Solar distillation is the process in which solar heat is used to purify water from an impure water source by evaporation and conden ...
In this new century, there is considerable pressure on the top six automakers to reduce their environmental and ecological footprint calculation. The automaker that wins the race to build and sell the superior car will shape consumer preferences, thereby boosting sales and profits. The winning firm will fashion a corporate strategy that drives automobile emissions to near zero while simultaneously providing high levels of performance, safety, and comfort. (more…)
Corporate environmental strategy (CES) involves the tools, management programs, processes, and product development choices that all ...
In the pursuit of superior cars, electronic products, and computing, several leading multinational corporations began in the last q ...
Although it is significant that many of the above four imperatives are qualitative, not quantitative, such new efforts have begun t ...
This latter form of new car taxes can actually serve as an impediment to higher fuel economy to the extent that increased energ ...
There are several options that, ultimately, must be integrated when attempting to realize a change in corporate culture: the legal ...